ORP are the primary controlling parameters for any process used in a wide variety of industries ranging from water,chemical,pharmaceutical, food processing etc.

Our online controllers are used to monitors these process parameters continuously and helps to take corrective action with its relay & current outputs. These reliable, accurate and robust meters are designed with a compact housing which fits in standard industry panel.

• Input 230 volts Single Phase 50/60 Hz
• Portable Pen Type/ Online ORP Meter Available
• ORP Mini Controller, Min Range: -1000 to +1000 mV/ or Higher Range
• 4-20 MA recorder output, 230V
• ORP electrode for continuous flow-thru monitoring

• RANGE 0 to 1 ppm
• ELECTROCHEMICAL BASED
• IMPORTED /1 No SS BODY SENSOR
• OUTPUT 4 – 20 mA
• Working Temp : 0 -45 DEGREE CENTIGRADE
• Accuracy : + 5% at constant temp.
• Recorder output : 0-1 Volt and 4-20 mA
• Relay Ratings :220V AC, 1A, resistive load
• Power Supply : 220 VAC,50 HZ
• Instrument Case : ABS plastic.
• Status indicators for Alarm
• Sensor in flame proof Holder Optional

• No Oxygen Flow
• Oxygen Purity Indication
• No Ozone Flow
• Water level Sensor
• Digital Venturi Pressure Indicator
• Spark Protection
• Low voltage / High Voltage
• Low Pressure Oxygen
• Data Logging
• Gsm Data Logging Available

• Instrument : OZONE ANALYZER
• Operation : Continuous
• Make : Local /Imported
• Mounting : Bench top
• Measurement Principle : Dual Beam UV Photometer
• Concentration Ranges : 0-200gm/m3 or More
• Measuring unit : gm/Nm3 as standard (or %w/w as optional)
• Accuracy : max 0.5%
• Repeatability : 0.2%
• Ambient temperature : 0-50 deg C Non condensing
• Flow rate : 0 - 1 lpm
• Sample gas flow meter : inbuilt
• Display : OLED display
• Pressure drop : less than 3mbar
• Voltage Supply : 190 - 250Volts,AC
• Gas Ports : PTFE Tubing

• RANGE: 0-200 PPM
• Display: Large 4 Digit Backlit LCD
• Accuracy: 0.02ppm
• Linearity: 0.01% of FS Value
• Power: 16-35 VDC, 2 Wire
• Output: Isolated 4-20mA
• Enclosure: NEMA 4X, IP66
• MOC: Noryl and SS316
• Response Time: 90% in 60Sec
• Temp Limit: 0-50 deg C
• Type: Membrane Covered Polarographic

The use of ozone destruct unit is an essential safety measure when dealing with high concentrations of ozone. The excess ozone is a by-product of an ozone process. A few examples of this may be:

• Ozone Off-gassed from a contact tank
• Ozone within a disinfection chamber
• Ozone in a vent hood

• Ozone gas flow rate : 0 to 5 lpm (max)
• Ozone concentration at the inlet : 0 - 100gm/Nm3
• Ozone concentration at the outlet : 500ppb(max)
• Principle of working : Thermal destructor/Catalyst
• Temperature settings : 50 to 300degC
• Recommended Temperature : 150 to 200degC
• Temperature control : Thermostat setting
• Power supply : 230V,AC, 900Watts
• Gas ports : 3/4"BSP(M)
• Ozone Destruction capacity : 50gm/hr (max)
• Dimensions : 450 x 300 x 350mm